Announcement

Collapse
No announcement yet.

Why are my gas and temperature guages not lighting up on my 93 yj?

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Why are my gas and temperature guages not lighting up on my 93 yj?

    I went to replace the bulbs in my gauges and i find that the gas and temp gauge lights just dont work at all. Any idea what the problem could be?

  • #2
    Re: Why are my gas and temperature guages not lighting up on my 93 yj?

    You have to remove your panel. Yjs dash hold allot of moisture. Try to clean the contacts the build goes into. Also, follow the board, It's possibly they share a common end and it corroded away. You can get a new dash panel, or solder on a jumper wire.. I had a similar problem on my buddies old yj.. Good luck!
    2007 JKU - 3.8ltr MoNsTeR!!!
    4" Long Arm RC lift, Teraflex 4" rear coils, Teraflex HD steering stabilizer, ProComp Xtreme rims with ProComp extreme MT's (325/75/r16) Engo 9k Winch, RC Stubby Bumper, Ruggedridge stinger, Homemade Grille Insert, Evil Eyes, Mopar 55w lighting, Neoprene seat covers, Optima YellowTop, K&N CAI, Superchips Programmer, Viper Throttle Body, Body Armor Rear bumper and tire carrier 4ft FireStick. Smittybilt CRS, Smittybilt Front Fender armor (not installed yet - waiting till spring) A buncha other stuff and a shit ton of stickers

    1988 YJ Wrangler 4.2ltr I6 Weber 32/36 HEI 50k volt coil 8.8 ignition wires.
    31" duratracs on centerline aluminum rims on stock leafs (recently replaced no sag). CJ mirrors, Hardtop, Full steel doors, Softtop alf doors, homemade rock-doors, somewhere I lost my Trackbars, but my Sways havent "fell off" yet Jacked Up Speakers, rattlecan primer, lots and lots of rust, sometimes its not visible through all the mud!

    Comment

    Working...
    X